Project & Case
Contact Us
- Address: Guangjian Building, No.12 – Wangcheng Road, Luoyang, China
- Zip Code:
- Email:
- Phone:
- Fax:
FAQ
-
2021-11-12What issues you may encounter after the glass enters the glass tempering …
As the glass temperature is relatively low when it just entered the glass tempering furnace, the temperature of its lower surface will be affected by both the ceramic rollers with which it gets in touch and the bottom heating elements……
-
2021-10-12What should you do if the glass sheet is stuck to the ceramic rollers duri…
During glass tempering process, in cases the door of the glass tempering furnace is not opened in time and the heating time is too long, or the primary conveyor of the glass tempering machine stops, or other malfunctions occur……
-
2021-09-14What are the production modes of LandGlass B-type bending glass temper…
LandGlass B-type bending glass tempering furnace production modes are as follows: 1. Single-station production mode, 2. Multi-station production mode, 3. Continuous production mode.
-
2021-08-16What are the requirements for cleaning brushes used on Low-E glass duri…
During the glass tempering process, because of the special properties of the glass coating material, the coated surface of the Low-E glass has higher requirements on the cleaning brushes in the washing machine unit.
-
2021-07-13What are the requirements for the placement of glass sheets on the loadin…
The glass sheets placed on the glass tempering machine loading table should be uniform and reasonably spaced, so as to ensure an even distribution of temperature in the furnace chamber and on the ceramic rollers in the chamber.
-
2021-06-17What should we pay attention to when tempering high borosilicate firepro…
Because of the ultra-high softening point and extremely low thermal expansion coefficient of high borosilicate fireproof glass, it creates a great challenge for tempering. With the flatness guaranteed, high borosilicate glass……
-
2021-05-28How to adjust the curvature of B-type hard shaft bent glass tempering m…
During glass tempering process, if the curvature needs to be adjusted, the following steps are required: Firstly, make a bending mold for the glass according to the curvature of the bent tempered glass to be processed…
-
2021-05-12How are the ceramic rollers of the glass tempering furnace installed?
To install the ceramic rollers of the glass tempering machine, a roller carrier is to be placed near the position where the rollers are going to be installed.