Project & Case
Contact Us
- Address: Guangjian Building, No.12 – Wangcheng Road, Luoyang, China
- Zip Code:
- Email:
- Phone:
- Fax:
FAQ
-
2021-04-13How to adjust glass flatness using the wind deflector of the air distribu…
If the tempered glass bends upward, it indicates that the wind pressure on the upper part of the chiller in the tempering section is lower. You should adjust the wind deflector of the glass tempering furnace downward.
-
2018-01-25How to Test the Quality of Architectural Flat Tempered Glass?
How to Test the Quality of Architectural Flat Tempered Glass?
-
2017-02-27What type of glass tempering furnace is the best choice for tempering ult…
Continuous Tempered Glass Machine of LandGlass will be your best choice for tempering ultra thin PV glass.
-
2015-07-06Tempering Furnace Maintenance on Key Parts (2)
1、Furnace Top Lifting and Transmission GearsTo ensure the smooth lifting of the furnace, the trapezoidal lead screw rods inside the pillars need be lubricated with N46 oil after every lift (or at least once a month). Apply lithium grease to the bev
-
2015-06-20Tempering Furnace Maintenance on Key Parts (1)
Ceramic roller is one of the key parts in glass tempering furnaces. The quality of the roller and its installation directly affect the product outcome.1、Regular Roller CleaningWhen the optical effect of the glass is less than desirable or there is
-
2015-03-02Instructions for operating loading Table Foot Switch
The loading table of LandGlass tempering furnace is equipped with a machinery foot switch, which serves as an adjusting micro-inching unit during placement of the glass in the furnace. The following instructions should be followed for handling the sw
-
2014-10-20Solutions to Spontaneous Explosion of Tempered Glass
Spontaneous explosion tends to occur to tempered glass and the following reasons account for it: 1. There are nickel sulfide particles in the glass sheets; Solution: check the quality of the glass sheet to see if there are stone like impurities,
-
2014-09-29How to Deal With the Automatic Restoration of HMI Default Values
At the running state of PLC, the automatic restoration of HMI default values occurs in the following cases:1. When the communication cable of the electric control cabinet is interfered by the external interference source;